A few prints
A few prints

The finger was printed with Craftware at the lowest easy setting.
Bracket was printed from Craftware at easy high setting.
The large timing pulley I ended up using Gcode from Slic3r because Craftware couldnt generate the code.
Small Pulley was Craftware at easy high setting.
The GPS case was easy high on Craftware.
So far everything is within 10 thousandths of and inch or .25 mm which is impressive considering the retail price of the printer.

October 15, 2015

308 posts

0 replies

To start a discussion or reply to a post please Login or Create an account.