Hi all, I'm trying again to use craftware but again an issue... After slice print start, bed and nozzle go to temperature, got it then..... Nothing! What I'm wrong?
On same serial port use repetier every day no problem...
I have a anycubic delta plus, using USB port. Configured as serial port

March 17, 2018

Marco85 Marco85
Beginner
4 posts

3 replies


Save the gcode and feed it to your printer from repetier.

March 21, 2018

Janos Janos
Admin
603 posts

ok... but i use repetier in this way :-)... craftbot is not able to do the entire process ?

March 23, 2018

Marco85 Marco85
Beginner
4 posts

CraftBot is able to do, but don't you have Anycubic delta? CraftPrint the print control software was written for CraftBot. However, our slicer CraftWare is able to produce nice gcode output for your printer.

March 24, 2018

Janos Janos
Admin
603 posts
To start a discussion or reply to a post please Login or Create an account.