Hello, I find it annoying when I preheat the heads or table only to find that a timer shut them off. I am assuming this is a safety feature and is firmware related. I usually bring temps up at the CB3 or using the app when I am designing a part or programming it so I don't have to wait when it is ready to print. Quite often the CB3 shuts everything off after some time of inactivity. Is there a way to prevent this? Also, can you add a touch and hold or a way to type in the temperature in the app? Right now if you have the bed set to 110 and want to go down to 40, you have to press the minus button 70 times.

January 26, 2019

Wayne95 Wayne95
Beginner
14 posts

1 reply


Although not talked about often, its not good practice to keep the extruder heated without filament moving through it any longer than required. When you see people post how their nozzle seems to clog all the time, these are people who leave their hot-end heated when not being used. Some filaments are worse at causing a problem than others.

Now heatbed, not a problem. Hopefully the timer for that is much longer.

May 4, 2019

Allen67 Allen67
Beginner
30 posts
To start a discussion or reply to a post please Login or Create an account.