Z Hop after jam purge - how to / Feature Request

Was using 0.8 nozzles and there was about 10 times it said there was a jam and went to purge. I noticed that it would ram through slightly higher spots the model when returning to the print. it the print was high it could be knocked loose.

Is there some G code that can put that would allow this? Another way? If not i think this would be a good feature to be able to toggle on and off.

Thanks!

May 21, 2020

James James
Beginner
1 posts

1 reply


Thanks for the info. I have forwarded your request to the firmware development team.

May 22, 2020

Janos Janos
Admin
581 posts
To start a discussion or reply to a post please Login or Create an account.